read back from the scratchpad and compare the data read back to ensure they are the same as the data sent to be written.issue a read scratchpad command and get back the ending address/data status register (E/S).issue a read scratchpad command and verify the address to be written to.send the memory address to be written to.select the device you are going to communicate with.Content has to be written to the scratchpad memory first and can only be written permanently after it is verified. Write to the memory is a bit more complex. Select the device you are going to communicate with.At a high level, to read from the 1-Wire EEPROM you will need to: I’d suggest that you read the datasheet a couple of times if you are not familiar with it already. In this blog posting, I will show you how to how to communicate with DS28EC20 using the popular Arduino platform.ġ-Wire is a rather complex protocol.

Like all other 1-wire devices, only a single pin is needed for both power and communication. DS28EC20 is a 20Kb 1-Wire EEPROM chip from Maxim.

One wire arduino library